Weed-eater TWIST 'N EDGE 952711895 Manuel d'utilisateur

Please do not return product to retailer.Por favor, no devuelva el producto al lugar de compra.Veuillez ne pas retourner le produit au détaillant.1--8

10EdgingEdgingDirectionSCALPINGThe scalping technique removes unwantedvegetation down to the ground. Hold the bot-tom of the trimmer head about 3 inch

11Air V entsS Remove the wheel by pressing one of thebuttons. Clean the wheel and groove on themotor housing with a soft brush. Reinstallwheel (see AS

1210. Place spool into hub with cut out area ofspool in line with eyelets (see illustration).Cut outarea of spoolEyelet11. Remove one line from notch

13TROUBLE CAUSE REMEDYTrimmer headstops under aload or does notturn when switchis pressed.1. Allow tip of line to do the cutting.2. Contact your autho

14LIMITED WARRANTYWEED EAT ER, a division of Husqvarna Con-sumer Outdoor Products N.A., Inc., warrants tothe original consumer purchaser that each new

2IDENTIFICATION OF SAFETY SYMBOLSW ARNING: This unit can be dangerous! Careless or improperuse can cause serious injury.Read the operator’ s manual be

3IDENTIFICATION OF SAFETY SYMBOLSWhen servicing unit, use only identical replace-ment parts.Never allow children to operate this unit.This unit is for

4WARNING: Trimmer line throws ob-jects violently. You and others can be blinded/injured. Wear safety glasses, boots, and legprotection. Keep body part

5S Do not overreach or stand on unstable sup-port. Keep firm footing and balance.S Keep the cutting head below waist level. Donot raise handles above

6NOTE: If shield is not properly installed, dam-age to unit (including motor failure) will result.1. Place the shield onto the motor housing.Ensure th

7HEIGHT AD J UST MEN T1. Turn height adjuster in the direction indi-cated to unlock (see illustration).HeightadjusterLockedUnlocked2. Adjust the lengt

8POWER CORDThe POWER CORD is where you attach yourextension cord to the unit.TRIGGER SWITCHTheTRIGGERSWITCHisusedtoturnontheunit. Squeeze the trigger

9S Repeat until you hear the line hitting againstthe line limiter pin (do not repeat this proce-dure more than 6 times).If problems are experienced wi