Weed Eater TWIST-N-EDGE 530086934 Manuel d'instructions

R TrademarkWARNING:Read and follow all Safety Rules and Operating Instructions beforeusing this product. Failure to do so can result in serious injury

10LIMITED WARRANTYELECTROLUX HOME PRODUCTS, INC.,warrants to the original purchaser that eachnew Weed Eater""""brand gasoline tool

11replace as necessary” shall be warr anted for 2years. Any warranted part which is scheduledfor replacement as required maintenance shallbe warranted

2SAFETY RULESWARNING:When using gardeningappliances, basic safety precautions must al-ways be followed to reduce the risk of fire andserious injury. R

3CUTTING SAFETYWARNING:Inspect the area beforeeach use. Remove objects (rocks, brokenglass, nails, wire, etc.) w hich can be thrownby or become entang

41. Remove wing nut from shield.2. Insert bracket into slot as shown.3. Pivot shield until bolt passes through holein bracket.4. Securely tighten wing

5To avoid engine problems, empty the fuel sys-tem before storage for 30 days or longer.Drain the gas tank, start the engine and let itrun until the fu

6Do not run the engine at a higher speed thannecessary. The cutting line will cut ef ficientlywhen the engine is run at less than full throttle.At low

7SweepingEDGING-- Adjust trimmer to the edging posi-tion (see TWIST AND EDGE section). Allowonly the tip of the line to make contact. Do notforce trim

8SERVICE AND ADJUSTMENTSLINE REPLACEMENTPre--wound spools offer the most convenientmethod for replacing line and ensuring opti-mum performance.SReplac

9SEASONAL STORAGEPrepare unit for storage at end of season or ifit will not be used for 30 days or more.If your unit is to be stored for a period of t